OPTIMISED MIG/MAG SETTINGS
Welding processes : Standard, Pulse, Pulse in Pulse, Cold pulse and Manual.
Trigger modes : 2T, 4T, SPOT, DELAY and TACK function.
Precise control over the welding cycle : CreepSpeed, Softstart, Hotstart, Upslope,
Downslope, Crater Fill, Post gas, etc.
2 specific compartments to isolate and avoid pollution of the aluminum coil:
- steel wire Ø 0.6 / 0.8 / 1.0 mm (upper compartment n ° 1)
- stainless steel wire Ø 0.8 / 1.0 mm (upper compartment n ° 1)
- aluminum wire Ø 0.8 / 1.0 / 1.2 (lower compartment n ° 2)
- CuSi and CuAl wire Ø 0.8 / 1.0 mm (upper compartment n ° 1)
SIMPLIFIED WELDING
57 (Adjustable) synergic curves ensure an outstanding weld for a large range of
materials, wire sizes and gas.
The fully synergic mode calculates the optimal welding parameters automatically, this can be
also be adjusted (wire speed, voltage and current).
MAXIMUM PRODUCTIVITY
4 microprocessors to give four times the processing power.
3 wheel drive system with 2 active drive rolls.
Up to 3 wire reels of Ø 200 mm accepted.
Automatic torch detection while pulling the trigger.
Balancing arm with torch support (x3) and welding helmet
Push pull torch compatibilty (24V)
Spool Gun compatibility (ideal for soft wire(AlSi5 / AlSi12).